本店产品默认为物流货运（需客户带上货主身份证自提货物）。一般南方、中部地区及沿海地带3―5天内可到达。西部、北部较远地区及少数需要二次中转的地区5―8天左右可到。如果受到不可预知因素的影响（天气和路面状况），本店提供的到达时限和提货地点仅供参考。如需发快递,快递费到付，本产品的包装比较大，建义省外买家尽量选择物流货运，因物流货运价格相对比较便宜，谢谢!
由于灯具属易碎品，不接受平邮，只采用物流运输。除特别注明外。
快递运输：适用于重量较轻的产品。运费价格适中，送货上门，方便快捷。全国各地均可到达。
物流运输：适用于多件或大件产品，运费较低，安全实惠。需要买家自己提货。
由于物流公司线路变动而偶尔有个别所列地址已不能到达时，我们会及时联系通知您再行决定。
以下所谓运输时间，仅指我们发货后，正常情况下通常的到货时间。但由于极少数的不可预知的意外，偶尔可能发生延误。在此情况下，我们承诺全力配合查询、跟进、催促，但无法做到完全担保，买家不能以此作为差评、投诉的依据。
快递：一般县级以上城市5天内；偏远地区或乡村5～7天。（极少数地区可能不提供送货上门）
物流：中部/南部省份：直达地区1～3天；需中转地区5天左右；
北部/西部省份：直达地区5～7天；需中转地区7～10天。
发货后8天以上仍未收到货的，请及时联系我们以便查询、跟进！
Safety Notice for Using:安全使用注意事项
1. Please use the panel light out of its package.
产品只能使用在包装外使用。
2. Before starting use of the light, please check if the light was damaged during transportation, if any damage shown, please do not install or use it.
在使用前，需确认产品在运输中有没有被损坏，若有损坏就不能安装使用。
3. Any maintenance should be performed by trained professionals only.
不要尝试自己维修，只能由专业工程师去维修。
4. Keep packaging material away from the reach of children and pets. Risk of suffocation!
包装材料要远离小孩，防止小孩玩耍导致窒息！
5. Caution！The packaging contains small parts that may be swallowed by children.
注意！包装材料含有小的配件，可能被小孩吞食。
6. Never leave children unattended in the vicinity of the lights and do not allow them to play with electrical devices.
让小孩远离产品，更不要让小孩接触带电设备。
7. Try to avoid looking directly in the LED beam-especially for extended periods of time. Do not shine the LED light in another person’s eyes.
避免长时间直视LED的发光面，不要用反射的LED的光去照射别人的眼睛。
8. Never cover the lights by other objects.
不要在产品上覆盖任何物品。
9. Never allowed the light to come into contact with open flames or external heat sources.
产品要远离明火或高温物体。
10. The products need to re-repair inspection or special treatment of retirement after service time.
产品过了使用期限，需要重新维修检查，或报废处理。
Maintenance:保养注意事项
1. Prior to cleaning the light, make sure it has been disconnected form the power supply.
在清洁灯具之前，请一定要关闭电源。
2. Use a dry or slightly moistened cloth for cleaning. Never use any chemicals or abrasives for cleaning.
请用干燥或较干燥的抹布进行清洁。不要使用化学或有腐蚀性的东西去清洁。
Disposal:旧品处理
1. Used electronic devices must be collected for recycling and cannot be deposited together with daily garbage.
电器产品提倡循环使用，不要和生活垃圾放置在一起。
2. Use only the LED drover included, and do not connect the surface-mounted lights to other loads.
要使用灯具的LED专用驱动器，不要和其它的灯具混用。
3. Do not remove the name plate of the power supply and driver of the light.
不要将灯具电源，驱动器的铭牌撕掉。
Installation:安装注意事项
1. This product should be installed by trained electricians.
产品的安装必须是持证的专业电工。
2. Check integrality of the products when unpack the packing.
从包装箱里拿出时要检查产品的完整性。
3. The distance between the light and any flammable materials must not be less than 0.2m. The distance between the upper part of the installed light and the ceiling must not be less than 2cm.The light must not be installed into ceilings or walls that contain heat-insulating material. The main cable must not connect with the low voltage cable or the surface-mounted lights.
产品与易燃材料要保证至少0.2m距离，要保证被安装的天顶有2厘米高的间隙，灯具不能全部安装在天顶的里面，或有热源的墙边，要注意低压与高压电线分开走线。
4. Guide the lights’connecting cables through the drilled-out hole, and fix the surface-mounted lights with the pre-fitted clips. Make sure that these are securely connected to the base material.
灯具上的电线可以从钻孔中通过和灯具后面的电线可以用电线夹固定，要确保固定牢固。
5. When laying the cables, make sure that the cables and plugs are not subjected to any tensile or twisting forces. Fit the cable tension relieving mechanisms to the connection points of the surface-mounted lights .Do not kink cables. Output cables should be laid separately and at a distance from other cables.
要确保灯具的电源线有足够的长度，不要受到张力或切向力。安装灯具的联机时避免过大的拉力，不要使电线打结。输出电线要注意区分，不要和其它灯具混淆。
6. After installation, connect the transform to the mains supply.
安装好后，将灯具低压插头与开关电源低压插头进行连接。
Notes:注意事项
Non-professional are not allowed to disassemble and maintain the products. We have the right not to provide after-sale service if unauthorized disassembly and maintenance happens to the products.
非专业人员不得进行拆卸，维修，我司有权对私自拆卸，维修的产品不给予更换或保修服务。
